How to Reset Roomba - Roombasmarti

You can reboot a Roomba by pressing and holding the Clean button for about 20 seconds. The light ring around the bin lid will start to glow white, indicating the reset was successful. The reboot process is complete once the light ring stops glowing, which may take up to a minute and a half. 

You can also reset a Roomba by pressing down the Dock, Spot Clean, and Clean buttons at the same time. Keep pushing them down until you hear a beep tone, which can take 10 to 20 seconds depending on your model. Note that 900 series Roombas won't beep once reset. 

To perform a factory reset on your Roomba, follow these steps:

1. Locate the "Clean" button on your Roomba. It is usually a large round button with a clean symbol or the Roomba logo.

2. Press and hold the "Clean" button for about 20 seconds. You may need to use a pen or a small object to press and hold the button if it's difficult to reach.

3. After approximately 20 seconds, you should see the Roomba's indicators or lights turn off and then back on. This indicates that the reset process has started.

4. Release the "Clean" button. The Roomba will play a series of tones or chimes to confirm the reset.

5. Wait for a few moments while the Roomba completes the reset process. It may take a minute or two for the Roomba to fully reset.

6. Once the reset is complete, the Roomba will power off. You can then turn it back on by pressing the "Clean" button or by placing it on the Home Base (if applicable) to charge.

Please note that performing a factory reset will erase all stored settings, maps, and Wi-Fi network information on the Roomba. After the reset, you'll need to set up your Roomba again, including connecting it to Wi-Fi and configuring any desired settings.

If you need further assistance or encounter any issues during the reset process, refer to the user manual for your specific Roomba model or contact iRobot customer support for guidance.

Know more to visit:  how to reset Roomba